Small changes for peer review

paper.tex

@@ -101,7 +101,7 @@ requirements of a QKD system.
 
 \begin{figure}
     \begin{center}
-        \includegraphics[width=0.5\textwidth]{fiber_passthrough_mech_model__8290_small.jpg}
+        \includegraphics[width=0.7\textwidth]{fiber_passthrough_mech_model__8290_small_annotations_censored.pdf}
     \end{center}
     \caption{Photo of our mechanical prototype. The prototype's two rotating tamper sensing meshes are shown in pink.
     The primary mesh is mechanically attached to and driven by the IHSM's rotating tamper sensing cage, which is
@@ -112,7 +112,8 @@ requirements of a QKD system.
     are fed through from the shaft to the interior of the IHSM cage through channels in the green part of the bracket.
     Only one optical fiber is shown here for clarity. The small tabs on the  primary and secondary meshes' protrude
     into the slots in this bracket such that they do not interfere, and leave only \qty{3.4}{\milli\meter} of space in
-    the narrowes parts of the bracket below the slots.}
+    the narrowest parts of the bracket below the slots.
+    \\\textbf{Note: Institutional logo removed from picture for peer review}}
     \label{fig_pic_proto_intro}
 \end{figure}
 
@@ -488,9 +489,9 @@ resulted in a difference below the measurement floor of approximately \qty{0.25}
 
 \begin{figure}
     \begin{center}
-        \includegraphics[width=0.45\textwidth]{fiber_passthrough_mech_model__8288_small.jpg}
+        \includegraphics[width=0.45\textwidth]{fiber_passthrough_mech_model__8288_small_censored.jpg}
         \hspace*{5mm}
-        \includegraphics[width=0.45\textwidth]{fiber_passthrough_mech_model__8292_small.jpg}
+        \includegraphics[width=0.45\textwidth]{fiber_passthrough_mech_model__8292_small_censored.jpg}
     \end{center}
     \caption{An disassembled view of our optical passthrough mechanical prototype. The fiber is passed through from the
     shaft going through the IHSM's primary tamper sensing mesh cage to the outside into the interior of the IHSM through
@@ -498,6 +499,7 @@ resulted in a difference below the measurement floor of approximately \qty{0.25}
     separately. In this prototype, the secondary mesh is driven by a cooling fan. Both independently rotating meshes
     have tabs that extend into the bracket such that they do not interfere, but reduce the space available to an
     attacker. The HSM's primary mesh cage is partially shown in white.
+    \\\textbf{Note: Institutional logo removed from picture for peer review}
     }
     \label{fig_pic_proto_detail}
 \end{figure}